Questions & Answers for: replacing wiring headlight switch 1993

Question about 1993 F250

1 Answer

...1993 Ford F250, 2 fule tanks, 5,7 engine. Truck was idleing, engine quits like it is out of fuel. Is it posible that the fuel tank switch shorted? Smell of burning wire after engine quit. Where to ...

Ad

...taillights not changed piggy back wiring and switch does samething check to see if someone has has spliced into rear wiring for the use of trailer hitch,this is usually where i find the most ...

Ad

...f250 just went out. then after afew seconds they go right back on. I replaced the dimmer switch, but im stuck there.. check or replace the ground wires at the headlights,especially the side the ...

...1993 Ford F250 and the headlights only have failled. They were going out intermitantly but they would come back on when I would mess with where the turn signal meets the steering column. Is there ...

...headlight switch, relay and the fuse. You need to replace the twilight sentinel day time running lights module.Also be fore replacing it make sure you have a power supply comming from the pink wire ...

Question about 1993 F250

1 Answer

1993 f250 diesel, lately the truck will not start. No ignition power, checked batteries they show 12.45v, but no signal on the cluster. It's like the batteries are dead. When you turn the key it makes

Question about 1993 Cherokee Country

2 Answers

headlight switch 3 times= wiring harness has one wire that has melted plastic on harness just enough that will not stay conducted= i had one person tell me to put vasaline in wiring harness and one to

1992 F-150 - multiunction switch location When light switch is on the high beams work but the low beams flcker Faulty headlight switch

Question about 1986-1993 Chevy S10 Pickup Carpet Dash Cover CDCP3CH7249 - Dashboard Covers

1 Answer

...headlight switch but the problem remains. Either the Yellow or Brown wires coming from the Headlight Switch is touching ground...Disconnect connecter from headlight switch...Remove BOTH ...

...headlight switch melted. Connectors melt when the wiring is of too small gauge to handle the amperage required, and the copper becomes overheated and burns. Replace any wiring or connectors that ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...