Question about 2003 Impala
...WHEEL BY HAND. IF BOTH CHECK OUT THE PROBLEM IS IN THE WIRING TO THE HUB. THE RIGHT FRONT HUB USUALLY HAS A BEND, DOWNWARD THEN UPWARD NEAR THE CONNECTOR TO THE HUB. THAT IS WHERE THE PROBLEM USUALLY ...
...replacing the harnesses to both front wheel speed sensors. The traction control activates because the system thinks a wheel is slipping. If you slow down at a slow rate the abs might activate
...replacing the harnesses to both front wheel speed sensors. The traction control activates because the system thinks a wheel is slipping. If you slow down at a slow rate the abs might activate
...replacing bearings seems to fix the problem but it comes back after a while. You can test the speed sensors yourself... Front sensor specs: 956 to 1240 ohms in 41 to 110 degree weather at least 100mV ...
...Replacing the front wheel bearing/hubs can be a big job for the inexperianced. Briefly... Remove tire/wheel Remove brake caliper assembly, do not remove brake line. Remove caliper bracket. Remove ...
broken wire going to front hubs It is your abs sensor wire. If you know how to solder & heatshrink you may be able to repair. If not you will need to replace the abs sensor from that wheel.
...front hub bearings and struts and I still feel like there is still a bearing problem Have you look at the rear bearings and also are the tires cupped, cupped tires will give you a bearing type noise ...
...front wheel bearing.the bearing is a sealed unit and you cant grease it.just replace it. Unfortunately you do not always get "play" in the bearing and they are unserviceable. Replace the entire unit. ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions