How do you relace an ECM on a 1998 saturn SL1? This requires a scanner that will perform a burn on the EEPROM and A/T adaptives . A non programmed ecm installed will not work. Be aware of this before ...
replacing it first. If you keep getting the problem, then you need to worry about your wiring harness or ECM. The temp sensor itself can be replaced with an OEM sensor from your local auto store. Then
I need to replace a computer brain box for my 2001 Saturn L series Wagon. I'm thinking it is located behind the glove box on the passenger side but how do I get to it? The ecm is buried under the ...
...ecm, by replacing it could it have an effect on the gas mileage performance? Always disconnect the battery before replacing any computer parts. And yes mileage should get better. Yes, you should ...
Question about 2006 Vue
2006 Saturn vue, 4 cylinder. Ran out of gas, couple gallons put in, ran fine. Went to gas station filled up full. Driving home, noticed my reduced power indicator flashed a few times on then off. Once
Question about 2003 L-Series
2003 saturn l-series l300..I replaced throttle body and was still getting reduced power and started blowing controls b 10 amp fues when key was on so i traced it to the ecm/pcm. Replaced it and then ...
Question about 2002 VUE
02 vue was hard to start , then wouldnt changed cam and crank sensors and found fuel in the oil. now runs for ten minutes and dies wont re start have 9 codes all having ecm in common replace that next
no injection pulse on a 2003saturn vue i have replaced the pcm and the ecm and new fuel pump and injectors an pulse to injectors the ecm was used all others new any help thx The ECM will only pulse ...
Question about 2003 VUE
I have replaced two two camshaft sensors on my 2007 Saturn outlook Xr for code 336 and no results please help Who replaced the sensor ? You or a repair shop ? The DTC P0336 does not say to replace a ...
Question about 2003 VUE
2006 Saturn Ion dies at random, more often with AC or headlights on, presents P0601 (checksum error) and P0340 (cam sensor) codes. Ignition switch just replaced at dealer, no change. Restarts later. ...
Usually answered in minutes!
1,310 Questions
953 Questions
1,183 Questions
963 Questions
862 Questions