Questions & Answers for: Mazda replaced water pump car wont start

...car battery, and have a repair manual w/ you at all times for reference. disconect water temerature sensor and it will start straight away. Problem is in the pump if you are talking about diesel ...

...some gasline antifreeze, which will make water and gas mix, but it will take two or three bottles to take up two ounces of water. The fuel filter may be contaminated and will need to be replaced,

replaced. Last but not least is dirty injectors. While the fuel filter does a good job of filtering the fuel, it's not perfect. Over time deposits and tiny particles lodge themselves in the injectors.

...DOWN TO KEEP FROM DAMAGING THE ENGINE.CHECK FOR LOW COOLANT.YOUR OVERHEATING PROBLEM COULD BE CAUSED BY BAD THERMOSTAT OR WATER PUMP.CHECK PUMP WEEP HOLE TO SEE IF LEAKING.IF YES REPLACE WATER

i have a 1993 mazda mx6, have replaced fuel filter, water pump, distributor, crank sensor and plugs, but still wont start it might be a cmputer chip.

...replace the thermostat. If it doesn't over heat until you start driving , then suspect the water pump. The impellers can slip on the shaft and not have enough flow to keep it cool. No it does

...water pump is not leaking along with radiator cap and thermostat body. Overheat condition has no effect on battery - if it does not hld charge it is because it is chemically worn out and needs ...

...wire was melted to coil replaced them Over heating is a sign of poor coolant circulation (1) cooling fan on rad not engaging, (2) coolant bad, (3) water pump is on its way out, (4) not enough ...

replaced the serpentine belt on a mazda protege then the engine runs hot dropping voltage and now wont start at all is this all from the belt? Could be. The serpentine belt powers the alternator and ...