Questions & Answers for: Chevrolet Venture replace wiper arm

...not touch the window on the upper quarter when the blade arm is vertical. suggestions? sounds like a bent wiper arm that holds the blade,,, bent it a little .. make sure blade is on correctly

touch the window on the upper quarter when the blade arm is vertical. suggestions? rear wiper moter making sound the wiper arm is seized so either try and losen up the arm or replace it with a new one

REPLACE THE WIPER MOTOR ON A 2002 CHEVY VENTURE The wiper motor is under a component called the crank arm assembly.If you remove the plastic cover you will see a torx head screw.There is an arm coming

...replace the front wiper motor for my 2001 chevy venture. The wipers are not parking fully down, and the intermittent setting parks the wipers about half way up until it is ready to wipe again. the ...

...wiper arm (not shure that its a screw ,could also be a clip under the arm )how ever ,once it is out ,put -it rignt back at is rignt spot...if it is still wrong ...could be the shaft that is worn or ...

...wiper arm's pivot point have worn clean off, or are very close to gone. ---- The following solution is my 'get it working now' fix... it's not as official and/or costly as replacing the whole wiper ...

...arm. It's under a plastic cover on top of the wiper motor and connects to the wiper linkage. When it fails the wipers park in the up position. There is a tab sticking up from the frame that it needs ...

front wipers moving slow as possible ..replaced wiper motor and same problem exists. all of arms are lubed well with grease once disconnected from motor everything moves great by hand you dont tell me

...rain is coming ,ruin their wiper arm springs and have less wiping pressure too, so have to replace their arms at some point. PEOPLE STOP LEAVING YOUR ARMS IN THE UP IN THE AIR,OFF THE GLASS

...wiper arm postion? We replaced the front wiper arm assemble after the driver side spline was stripped. How do the blades "interact"? Does the passenger side arm rest on top of the driver ...