Questions & Answers for: how to replace a transmission in a 2003 impala

...while. Have the vehicle scanned. If you have a code in the computer for maximum adapt/ long shift, replace the EPC pressure control solenoid. This a real common problem on the 4t65e

transmission under the pan on the drivers side. To replace it you will need a lift and a trans jack. It is really hard to do on the ground because you have to remove the sub-frame from the car. If you

...replace the PCS and TCC Solinoids in my transmission and needs to know the location of the valves. He doesn't have computer access, so I am hoping someone here can help me so i can get him started. ...

transmission dipstick gasket for a 2003 cheverolet impala, to replace this part. Can you help me find somewhere to order from> Since it is just a gasket, i would check with the dealership. Although

...transmission fluid and then check your TPS (throttle position sensor) Check TPS for smooth and linear electrical response over the entire range of motion. If not, replace. Thank you for using fixya ...

...replace the torque converter. Also, Lubegard Shudder Fix will at least fix this for awhile. Or try a transmission flush by a shop that a dirty EPC valve screen could be causing a low transmission ...

my 2003 impala has terrible gas mileage and I've replace the Cat Converter and back ox sensor You my have a problem withe transmission or the clutches in it.

2003 chevy impala transmission slip went you start moving slip went you stop and start Sounds like worn clutches, more than likely the transmission needs rebuilt or replaced. Have u checked all your ...

...2003 it cutt off when put in Drive the reverse gear work will drive in low but when put into drive ,3 or 2 gear it cut off Low trani fluid check.Then if you have over 200000 km then I can tell this ...

...exactly where the neutral safety switches what I put the other transmission in I didn't even think to check about the safety switch I should replace it it is on the shift rod comming out of ...