Questions & Answers for: Husqvarna how to replace shock

Question about Designer I

1 Answer

Viking Designer 1 won't embroider I have a Designer 1 with about 67 hours doing mostly embroidery. It recently started to freeze up and after sitting overnight it would be ok again. Two days ago it ...

Ad

shock you cannot just remove the spring alone..if you want to replace it you have to do it as a whole set...there are two bolts connecting the shocks at top and bottom respectively..after replacing it

Ad

how do i check the oil level on a husqvarna te 510 2005 I have an 06 Husky TE510 and it uses a check bolt on the clutch side case not a dip stick. It works like a site glass only oil leaks out when ...

Question about Craftsman 36cc, 16 In. Gas Chain Saw

1 Answer

I bought it second hand and it won't start Take out the plug, earth the plug to the side of the engine with insulated pliers (otherwisw you will get a shock) switch the on switch on and give it a pull

Question about Craftsman 36cc, 16 In. Gas Chain Saw

1 Answer

I have an TE-450 2010 model and i want to lower it 1 to 2 inches with out upsetting the suspension.What would be the best way too achieve this.Can i change the shock linkage arm to lower the bike. ...

Question about Craftsman 36cc, 16 In. Gas Chain Saw

1 Answer

How to harden the forks and rear shock I'm finding my Front suspension and rear shock a little soft, how do I stiffen the rebound and compression Both are adjustable. The forks have an adjustment ...

Question about 2004 TE 510

1 Answer

shock absorber suspension settings,please all depends on your weight and what type of terrain your going on , trial and error so just adjust to suit your needs ! while standing on the pegs bounce up ...

Question about 2004 TE 510

1 Answer

how to test coil on husqvarna 288 take spark plug out hold it a millimeter away from head and it should spark or if you like getting shocked then hold the spark plug between your fingers i would not ...

Husqvarna TS354 XD, What is the easiest way to access the K66ELD fill ports to change the transmission oil? Tuff Torq suggests at 50 hours and every 200 hours thereafter. The fill port is on top of ...

How can i loosen a stiff right drive arm on my Husqvarna Z254F zero turn mower? I have a fairly new Husqvarna Z254F Zero turn mower. Since I have had it, the right drive arm stiffens up and is harder ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Husqvarna Sewing Machine Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Cindy Wells

Level 3 Expert

6688 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Are you a Husqvarna Sewing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...