replace the oil pressure sending unit? It's on the engine, right next to the starter, it has one wire going to it. You don't need to drain the oil. If the light is coming on, you may have bad seals in
Question about 1996 Jetta
...vw jetta oil light is on and there is a beeping sound what might be wrong HI. this is a failing oil pump. you will need to replace your oil pump and oil pump screen as well. this will fix your
...oil pressure switch 95 jeep grand cherokee 5.2 4wd. any tips on the best way to replace the oil pressure switch/oil sending unit? Use a deep well socket and extension, it lives by the
...volt meter I do have 12 volts going my cluster where the gauge recieves its signal from the sending unit could not have power or the fuse could be burnt out. Sometimes the sending unit does get
...the sending unit going bad? Yes this very well could be,but if you want to be sure then have the oil pressure checked.If it turns out good then replace the oil sending unit.Hope this helps.Good
...located on the side of the block by the oil filter where is oil sending unit 1995 olds achava I have a sever oil leak somewhere above my starter on a 95 Oldsmobile acheiva. What could be causing ...
oil pressure gauge jumping Have you changed the oil pressure sensor on the motor the sending unit could be bad
location 95 chevy pu oil sender unit need location of oil sending unit on 95 c1500 5.7 v8 Should be between the intake manifold and the firewall near the distributor.
Question about 95-97 Ford 7.3 Powerstroke F250 & F350 Auto 6 Position 4-Bank Chip
wont start hot just had oil change and filters replaced starts fine when cool check the maf sensor. and lead.
oil sending unit. The one time it wasn't the oil sending unit it was the oil pump had went out. I'm not sure this will help and I don't know how to check the oil sending unit. I just replaced the unit
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions