...Oil Pressure Oil pressure gauge is spiking well over 80 while driving. Truck does not appear to be making any unusual noises and is running fine. Oil level and all fluids are good. Is this a faulty ...
...OIL PRESSURE SENSOR OR SWITCH REPLACEMENT TOOLS REQUIRED J 41712 Oil Pressure Switch Socket REMOVAL PROCEDURE IMPORTANT: Clean the area around the sensor and Distributor before removal. Do not allow ...
...pressure, oil pressure, compression all good, even the Chevy house can't figure it out. Any suggestions? this is a comon problem on chevy 00-06 models a computer ground ,it seems ok at sight but ...
...oil pressure sensor electrical connector. Using J 41712 or equivalent, remove the oil pressure sensor. Fig. Using J 41712 or equivalent, remove the oil pressure sensor-8.1L engines To install: Apply ...
...replace the sensor. 4.8L, 5.3L & 6.0L Engines If necessary, remove the engine sight shield. Disconnect the oil pressure sensor electrical connector. Using J 41712 or equivalent, remove the oil ...
...oil pressure gauge fluxuating i have an '06 suburban and recently the oil pressure gauge began fluxuating from 0 to 80 on the gauge, checked the oil added a qt, but still have the same problem. would ...
...replace the oil pump and was a waste of money very expensive good luck I had the same problem in my corvette a few years back. I used a heavier weight oil which still dropped the pressure, but it cut ...
oil pressure gauge is showing 240 on start when i start my car the oil gauge going directly to the full (240) i'm always replacing the oil on time oil sending unit needs replacing. I just had ...
Question about 2007 Impala LS Sedan New Cars
...oil pressure sensor (I would replace the sensor while you at this)install the pressure sensor and washer to 15 lb ft.reconnect the oil pressure sensor. I HAVE NO IDEA WHAT YOU ARE REFERRING TO HERE. ...
Question about 2007 Impala LS Sedan New Cars
Replace an Oil Pan Gasket? http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-oil-pan-gasket.html ------------ HOW TO REPLACE AN OIL PUMP http://schematicsdiagram.blogspot.com/2011/07/how-to
Usually answered in minutes!
4,236 Questions
3,219 Questions
2,541 Questions
2,307 Questions
2,177 Questions