Questions & Answers for: HP LaserJet replace motor

Question about LaserJet 9500n Printer

3 Answers

...replace main motor 4L/4 Main motor problem, check gear train for binding. Replace main motor IIIP/IIP+/IIP Error 57-1 Incompatible memory can be either top or bottom slot. Also check motor cable ...

Ad

Question about LaserJet 5550 Printer

1 Answer

...motor. 4. Replace the DC controller PCB. Calibrate the printer after replacing the DC controller. Need HP Printer Support . Call Toll Free Phone Number - 877-690-9305 HP Printer Support 877 690 9305 ...

Ad

Question about LaserJet 5550DN Printer

1 Answer

...disengaging motor and J1100 for the DC controller PCB. Replace the developing disengaging drive assembly. Replace the DC controller PCB. Calibrate the printer after replacing the DC

Question about LaserJet 4mv Printer

1 Answer

3 (FM3) is defective. Switch the printer off and then back on. If the error continues: Check cabling between fan motor(s) and DC Controller PCA. Replace the faulty fan motor. Replace the DC Controller

Question about LaserJet 5550DN Printer

1 Answer

...motor witch ineed to replace ? and how to install the new one ? regards 59.C0 indicates the disengement motor problem. HP reccomends reseating J16 on the motor and J1100 on the DC controller Then the ...

Question about LaserJet 5200tn Printer

2 Answers

...motor 1st, 2nd replace the DC Controller. If you are not a printer tech, you will need one. Troubleshooting and Repair advice for the 52.00 Error on the HP Laserjet P3015 Printer The 52.00 Error on ...

Question about LaserJet M4345 MultiFunction Printer

1 Answer

the main motor, this is connector J98. For the print-cartridge motor, this is connector J86. 3 Replace the motor. See Main motor (M101) or Print-cartridge motor (M102). 4 Replace the dc controller PCA

Question about LaserJet 5550 Printer

1 Answer

...disengaging motor and J1100 for the DC controller PCB. 2. Replace the developing disengaging drive assembly. 3. Replace the DC controller PCB. Calibrate the printer after replacing the DC

Question about LaserJet 5550DN Printer

1 Answer

...If the connector is damaged, replace it. 2 Reconnect the connetors J38 for the ETB motor and J1111 on the DC controller PCB. 3 Replace the ETB motor. 4 Replace the DC controller PCB. Regards ...

Question about LaserJet 5100 Printer

1 Answer

...of the gears in the drive train. 3. Check the main motor cable to make sure that it is seated correctly. 4. If the error persists, replace the motor, and then replace the dc controller, if

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...