...Ideas???? This is because your map file has either been deleted or corrupted and needs to be replaced. Please see this link for more info. Too much info to copy & paste here: ...
...replace MAP sensor. After repairs, clear DTC and verify MAP sensor operation. 4. Turn ignition on. Measure voltage between ground and MAP sensor connector terminal No. 2 (Red wire). ...
...If the resistance is more than 5 ohms, then test the circuit for a high resistance. If the circuit tests normal, replace the ECM. If the MAP sensor circuits test normal, then replace the MAP
...replace the MAP sensor. Component Testing NOTE You must perform the circuit/system testing, in order to verify the integrity of the MAP sensor circuits, before proceeding with the component testing. ...
...voltage is present, then check for existing ground at the MAP sensor connector. If it isn't present then repair open/short in the ground circuit.If ground is present, then replace MAP
...hombre as the truck was spitting and backfiring and then finally just died yesterday found out the MAP was cracked so i replaced but now cannot start truck and smells like flooded Replace MAP
...replace the MAP and the old one could be good. But if the new MAP kills the Code, the old MAP was probably bad. The MAP measures absolute pressure in the manifold. This is measured in several ways, ...
replace as necessary. INSTALLATION PROCEDURE Install the MAP sensor (1) into the intake manifold. Install the throttle cable bracket and bolts. Tighten Tighten the bracket bolts to 12 N.m (106 lb in)
...map to replace your (outdated) map, subscribe/purchase it, download and install the map on your TomTom device, using the TomTom software, (e.g. HOME, or MyDrive Connect, depending on your GPS ...
Usually answered in minutes!
1,678 Questions
1,343 Questions
1,187 Questions
1,096 Questions
889 Questions