Questions & Answers for: Jeep Grand Cherokee how to replace a lifter

...removing anything you should pin point problem as in which lifter or lifters and consider buying a book.it will tell you where everything is and give a few possibilities of replace vrs. ...

Ad

...replace collapsed lifter 4.0l il6 Is their enough room to remove the lifter without taking the head off? What motor do you have? The V8, you can remove just the intake manifold and the valve ...

Ad

Question about 2001 Grand Cherokee

1 Answer

lifter tapping if a lifter is tapping in a jeep grande cherokee does the motor need to be replaced? or can the lifter just be replaced....... Yes, you can have just a lifter replaced, but it could be ...

...replace lifters on a 2002 jeep grand cherokee 4.0 depending all that is done about $300 dollars thats 12 lifters test 12 push rods replase rods $4.00 each rocker arm cover gasket oil filter and oil ...

excessive white smoke coming from exaust,and what sounds like a stuck lifter White smoke usually is from a failed head gasket. The lifter noise bothers me though usually meaning that you have water in

replace thaty lifter. if they are all making noise,you may have an oil pressre problem.or blockage in an oil passage to the camshaft. you may try an additive if the oil pressure is ok.a detergant type

replace the lifter. If I were to go through all the work of taking it apart again, I'd opt for a new lifter, Also make sure that the rocker and pivot aren't worn or you may be wasting your time there.

...told my lifters are worn eng. has a ticking noise more when cold. do i need to pull the head off to replace them? No, you pull off the valve covers and intake manifold, loosen the rocker arms, turn ...

...lifter on a 1996 jeep GC 4.0? replace the head,now i can not stop the ticking When my engine had a LOUD, persistent tick, I made sure that the engine was warmed up, turned it off, drained the oil, ...

Question about 2001 Grand Cherokee

2 Answers

lifter setup, you must replace all 16 lifters along with the cam and a proper break in procedure must be followed, and I highly suggest a ZDDP break in additive be used. And there will still be a good

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...