Questions & Answers for: Dodge Ram 1500 how to replace a lifter

Question about 2005 Ram 1500

1 Answer

...you're good to go. it's not very dangerous for the engine but in my opinion it's better to have it

Ad

very loud tick coming from drivers side, dodge replaced all of the lifters, still the same on the 5.7 this could be normal as the vehicle has roller lifters. the noise (tapping sound ) resinates down ...

Ad

...help before i drive my truck to the junk yard! I have a 2005 Dodge Ram 1500 SLT 4.7 v-8.... I would replace the sending unit. It is an easy and cheap replacement compared to solving low oil pressure ...

Question about 2005 Ram 1500

1 Answer

...lifter noise when it is cold. What does that mean and what can I do about it? Over time and miles the lifters tend to collapse and the only way to quiet the noise is to replace them or use something ...

the motor is knocking. what could be the reasons for this. just got it back from a shop. they replaced the head. and a coil. possible out of time( check timing with timing light)could no oil, or ...

Question about 2000 Ram 1500 Truck

2 Answers

...replace the oil filter, and fill with oil, then you're good to go. You could have a hydraulic lifter that has went bad. It will make a ticking sound when the oil has drained from it and you start the ...

I just replaced oil pump in 2004 dodge ram 4.7 and now there's a ticking noise. What could it be? There's probably oil trapped in the lifters.  As long as you have good oil pressure. If ...

Question about 2004 Ram 1500

1 Answer

replace the lifters I want to replace the lifters in my truck and would like a step by step manual I have found that the service manuals at pep boys covers all the engine teardown and reinstall ...

I have a 2003 Dodge Ram 1500 4.7 with 166k still ticking after lifters replaced. The engine started developing a top end tick and threw the rocker arm off. I pulled the valve cover off and replaced ...

...replace a lift on a 2005 dodge ram 5.7 hemi I had a pushrod pop out of place. replaced pushrod and notice a lot of slack on the rocker. seems like a lifter stuck or collapsed and cannot find any info ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...