Questions & Answers for: GMC how to replace a lifter

lifter is bad do i have to replace the engine should be able to rebuild. sounds like you will need a new cam and lifter set. Cam and lifters could be replaced without completely rebuilding engine, but

...Make sure you are using the correct viscosity oil for winter temps. If it's from wear only parts replacement will fix it. have a 2001 chevy silverado with 5.3 vortex motor starts knocking in the ...

I HAVE A LIKE LIGHT KNOCK OR TICKING IN ENGINE ITS WORST WHEN ITS COLD ticking sounds that are worse when cold usually indicate a lifter issue or valve train Lifters require pulling the intake and the

the cam lobes could be worn if this is the case then your going to need to do a top end rebuild. to replace the hydraulic lifters your going to need to remove the cams so as you can get to the lifters

...lifter out of there and replace it with a new one, or a used one. For some reason, it is not getting oil. You might be finding more damage as you go. One of these days you are going to have to fix ...

...lifter or the valve itself you need to get a compression test done both wet and dry, look on your plug wires for any signs of resistance like white dots that is resistance find it's own path I would ...

...I get new lifters? What do you suggest. First thing to do is remove the oil pressure sending unit replace it with an oil pressure gauge. If the oil pressure is okay 30 to 40 lbs. idling and 40 to

can lifters be replaced loud knocking changed oil and filters knocking gets louder Oh yea, lifters can be replaced , best if you replace cam an lifters together ! Loud knocking is not usually ...

...replace the valve covers. Was wondering if there is an easy way to set the lifters? Before starting first put engine on #1 TDC compression stroke. Adjust #1 rockers such that you have zero lift (push ...

is there anything i could of missed after replacing number 3 valve lifters replaced lifters then did full tune up including oil change coil dis cap ect turns over but no start did you reconnect the ...