...this will remove the load and the fuse will remain good. Better still run a voltage check across the fuse line with a DMM, to save further damage to the TV. At best replace this power inverter
...of sudden bought tv on 2/22/09 outlet works fine if the tv al of a sudden stops working. the first thing you should inspect is the fuse. more than likelly it blew out on ya and replace with same
fuse for a 20" TV will be of about 3.5Amps, and if it is 110VAC, the fuse will be about 6Amps. Before replaceing the fuse, you just check for any short circuit inside the power supply reguator section
enerson lc401em2f blows fuse on board (BA01P0F0103 3) replaced 4 diode (1N5406, 3amp, 600V) Still blows fuse. If main fuse should blow up, surely there will be some short circuit in rectifier section.
Question about Lc320em1 TV
...LED TV, 6 months old. Fuse burnt, replaced, burnt again. Any suggestions? Emerson 32" LED TV, 6 months old. Fuse burnt, replaced, burnt again. Any suggestions? Bad Capacitor in the power supply
...it plugs in when replacing fuses in a device....if, when you next apply power to the device and it immediately blows the fuse again : Do NOT put in anymore fuses. It is time to visit a TV repair
Question about LC320EM9 32 in. LCD HDTV
...fuse blow when the TV is turned on? Put new fuse in and plugged it in and it blew. I replaced it with a 4 amp 125 volt fuse. that's what was in it. the fuse blows on your tv because and most likely ...
Question about LC320EM9 32 in. LCD HDTV
tv model# CR202EM9. It does not turn on. What might the problem be. No power at all? No red standby light? Might be fuse on power board. If fuse is ok and no fuse seen, then faulty powerboard. Emerson
Question about LC320EM9 32 in. LCD HDTV
...means that there is an issue and the circuit is not complete. Under state 1 replace fuse and power your tv and it has to go on. Under state 2 please have a qualified technician check the power
Question about LC320EM9 32 in. LCD HDTV
...inch long. Make sure if it is the fuse that you replace it with the same amperage fuse. I think there about 5 amps. If the fuse is blown you can solder the new one to the old one, piggy back style. ...
Usually answered in minutes!
422 Questions
267 Questions
265 Questions
155 Questions
150 Questions