Questions & Answers for: Dynex replace fuse tv

Question about 19 in. LCD Flat-Panel HDTV

2 Answers

...Fuse most likely did not  blow. Check for bulging capacitors on your power supply. A good cap should be flat or indented a bit on top.  A swollen cap would look dswollen replace them. There ...

Ad

Question about DX-LCD19-09 19 in. LCD TV

1 Answer

fuse might not working anymore. Replace new one.If your monitor is still not working, probably there is defected semi conductor of your monitor. Approach technician near to you...I hope this may help,

Ad

Question about DX-L26-10A 26 in. HD-Ready LCD TV

1 Answer

...fuse, chances are its blown if the set is dead after a lightning storm, unfortunately if you replace it there is a really good chance it will blow again, if it does then the rectifier diodes would be ...

Question about DX-L26-10A 26 in. HD-Ready LCD TV

3 Answers

...replace, as often these days i find in my shop anyway, many repairs can be very expensive, and often it would be better putting any monies that would have been spent on repair towards a NEW unit with ...

Question about DX-L32-10A 32" LCD HDTV

2 Answers

...replace it with a 10 volt 3 amp fuse) Most of the caps that go are 10V 1000uF or 3300uF. I found some great videos of the procedure (for many Samsungs with the same issue) on youtube. ...

Question about DX-L32-10A 32" LCD HDTV

1 Answer

day nothing the next day Try unpluging tv and hold down power button for one minute. Maybe tv will reset itself. Most tv have a fuse tiny you will have to remove back panel to replace. Hope this helps

Question about DX-L42-10A 42 in. LCD TV

1 Answer

...fuse then check it on a volt-ohm meter for continuity while it is out of the circuit, and if it is an open circuit, replace it. If there is a circuit breaker, then reset it. If these don't work, ...

Question about DX-L42-10A 42 in. LCD TV

1 Answer

...tv not on I see so many here with no sound/no picture issues: ISSUES: 1. IF sound main fuse/s are good. 2. If no power or standby check main fuse, standby power supply and any signs of damage you can ...

Question about 32 in. LCD Flat-Panel HDTV

1 Answer

...to replace the fuse on power supply board if busted or blown (it is usually connected directly from power cord. If the fuse still blown you need to replace the whole power supply board. please

...fuse which sometimes needs to be soldered to remove and replace. A little experience is required there. A lot of power surges will take out can capacitors on the power board. Some times the board can ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Dynex Televison and Video Experts

Cindy Wells

Level 3 Expert

6688 Answers

Grand Canyon Tech
Grand Canyon Tech

Level 3 Expert

3867 Answers

Jesse Walters
Jesse Walters

Level 2 Expert

337 Answers

Are you a Dynex Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...