...dried out from sitting either way the first thing I would check / replace is the fuel filter and if this doesnot correct the problem i would then rebuild the carb. Good Luck i hope this helps you ...
...fuel lines when I prime. What can I do to diagnose the problem? I have the same problem. I replaced the primer bulb, and the fuel lines. Still no gas to the bulb; (It ran fine before I replaced the ...
fuel out to the ground when I prime the bulb, most spit it back to the fuel tank however) See if priming it moves fuel. You should see a trail of bubbles in the fuel tubing. You have to see if you are
bulb no matter how many times you pump it, why? Three possibilities here.....clogged or gummed up fuel filter in inlet line in tank ....clogged inlet line or trash in carb on inlet lines or passages..
...fuel to squirt back into the tank when you press the prime bulb 6 or 7 time for a cold start. Once you connect both hoses to the carburetor, push the prime button a few times to make sure gas is ...
...replace the fuel bulb? Blower starts but leaks fuel while running. Homelite and Ryobi appear to be made by the same manufacturer. Home Depot now carries a "Fuel System Tune-Up Kit, AC04122," that ...
prime new filter/fuel lines, new blub Bulb or fuel line could have a crack or a clog in fuel line/filter or carburetor. Here's a video on how to change the bulb and fuel lines and another video on how
...Bulb or fuel line could have a crack or a clog in fuel line/filter or carburetor. Here's a video on how to change the bulb and fuel lines and another video on how to clean/rebuild the carburetor. ...
Question about Mighty Lite Blowervac
...fuel prime bulb and the carberator Don't know how to route fuel lines Hose just below primer bulb goes into tank and is shorter longer hose with fuel filter goes to other line on carb. Fast efficient ...
Question about Mighty Lite Blowervac
...replace the liquid in the fuel line over time, but so little air once it is primer again that the fuel pump can over come it with volume of fuel. Primer bulbs do not stay firm, as they are when ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions