...synchronize so don't pull out. also your fuel pump may be getting weak. you can try cycling key a few time to build fuel pressure before starts,replace fuel filter also and make sure air filter is
...fuel filter also Has it had a tune up? they need to have the plugs replaced at 100,000 if the fuel filter does not work then the most probable cause is the fuel pump is losing pressure when hot. The ...
...fuel filter or maybe a bad fuel pump. Check pressure with a gauge, should be 40 psi. also, a dirty MAF sensor can cause this. clean by psraying with carb cleaner a few times. disconnect battery to ...
...codes on my ford winstar say that it is runing lean on bank 1 and 2 what do i need to replace The fuel filter for starts,if this does not fix the problem,replace the fuel pump,it is in the fuel
fuel pump and filter replaced when the car would not start. I have a slight smell of gas inside the car when driving. What could be the cause? 2003 Ford windstar. The only thing that is going to cause
...sensors. No improvement. New mass air flow sensor and dealer replaced intake gaskets - no improvement. Complete random stalling is very frustating and dangerous. check fuel filter fuel pump ...
Question about 2003 Windstar
...fuel filter on a 03 ford winstar Tracy, If connectors are like in first video I linked,push line in on filter this will make tabs easier to push in, press tabs in on connector, then pull off hose ...
Question about 2003 Windstar
...fuel filter ? Sometimes with time, dirt collects inside fuel tank and clogs the filter which may cause your vehicle to shot off. Also check for any codes which may be present and causing your ...
Question about 2003 Windstar
...fuel filter, starter and battery all due to it not starting. It still will not start need some imput Most problems with Windstars are traced to the connector at the computer in the engine compartment ...
Question about 2003 Windstar
...is low replace the pump , if flow is low replace the fuel filter, check fuel pump has reserve pressure by quickly clamping and releasing the return line the pressure should up to 50 psi or
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions