Questions & Answers for: Jeep Grand Cherokee replace crankshaft position sensor 1999

no spark 99 JEEP GRAND CHEROKEE 4.0l HAD NO SPARK CHANGED COIL ROD CRANKSHAFT POSITION SENSOR AND STILL NO SPARK Check the asd relay in the fuse block. Replace it with a known good relay

...crankshaft position sensor or camshaft sensor. Could it be these or maybe the computer? Sometimes the horn will sound and the headlights will come on and off when someone is walking by or in the ...

replace a crankshaft position sensor on a 1996 how to replace a crankshaft position sensor on a 1996 jeep grand cherokee. tools needed & step by step instructions for "non mechanic". THANKS 1st I ...

...crankshaft position circuit as well ?Replace circuit wiring and/or connectors as required ?Diagnose/replace the PCM as required Hello! Code P0340 can also be caused by a defective Crankshaft Position ...

...crankshaft position sensor located and how do you replace it? Gi it is near the crank shaft at the bottom of the engine. You will most likely need to take it a shop - because it can ruin your car if ...

...crankshaft position sensor) or CKP (crankshaft position sensor. This code could be related to just a bad connection at either sensor or the wiring harness, check the connections and be sure they are ...

...on the machine and no codes. I replaced the fuel pump, filter, and crankshaft position sensor just in case, and still same problem. Please Help!!! check for back pressure on exchaust can be stopped ...

to get it running. found out that the crankshaft position sensor was going bad, cost 40$ for the part, but had to have mechinac replace it due to it's location, hard to get at. jeep runs great now

...Replace the crank sensor. The Crankshaft Position (CKP) sensor is mounted to the transmission bellhousing at the left/rear side of the engine block. The sensor is adjustable and is attached with one ...

where is the crankshaft position sensor on a 1999 jeep Grand Cherokee v8 4.7 Liter engine above the starter,right side of motor