Questions & Answers for: Dodge Durango replace crankshaft position sensor 1999

Question about 1999 Durango

1 Answer

...tire and right front wheelhouse liner. Disconnect crankshaft position sensor pigtail harness from main wiring harness. Remove two sensor (recessed hex head) mounting bolts Remove sensor from

Ad

Question about 1999 Durango

1 Answer

...CRANKSHAFT POSITION SENSOR - 3.9 - 5.2 - 5.9L ENGINES REMOVAL The sensor is bolted to the top of the cylinder block near the rear of right cylinder head Note: The sensor is accessed by removing the ...

Ad

Question about 1999 Durango

2 Answers

...replace the crankshaft sensor on my 1999 durango? no you dont have to remove the transmission it on the passenger side under a bracket at the corner of the tranny. if you remove the backet you have ...

Question about 1999 Durango

1 Answer

...replace the crankshaft sensor, is this necessary? Is there another way? what engine?if it's a 5.2 l V8,you could remove right inner fender shield for easier access..i would not remove trans..if you ...

...crankshaft position sensor is on the right side of the engine just to the rear of the right hand exhaust manifold, the sensor is attached to the block with two bolts, part of the sensor overhangs the ...

Question about 2001 Durango

1 Answer

...Crankshaft Position Sensor (CKP) is mounted into the right-rear side of the engine block. 5.2L & 5.9L The Crankshaft Position (CKP) sensor is located near the outer edge of the flywheel (starter ...

Question about 1999 Durango

1 Answer

...Crankshaft Position (CMK) sensor is located near the outer edge of the flywheel (or starter ring gear). On other models it is fitted to the right side of the engine block. The only test you can ...

crankshaft position sensor a circuit malfunction change the crankshaft position sensor.when they go bad ,they leak oil and contaminate the plug.use brake parts cleaner to remove all the oil.

coils for spark. Before replacing the crankshaft position sensor check the ASD relay in the under hood power dist. center ! this relay powers the ignition coil an the fuel injectors an the O2 sensors

engine ? Is there B+ voltage at the dark green with a orange stripe wire at the coil ? key on ! No B+ voltage check ASD relay . If there is B+ voltage count on it being the crankshaft position sensor

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

1999 Dodge Durango
1999 Dodge Durango

2,049 Questions

2000 Dodge Durango
2000 Dodge Durango

1,616 Questions

2001 Dodge Durango
2001 Dodge Durango

1,378 Questions

2002 Dodge Durango
2002 Dodge Durango

886 Questions

2004 Dodge Durango
2004 Dodge Durango

1,005 Questions

Manuals & User Guides

Loading...