...replace the shaft seal on the drivers side output shaft but I can't seem to find what type of oil to use and where the fill plug is. Any help? vr Wes The plug should be just slightly above and to the ...
...to push out of place, if this is the case recommend you to replace short block will be chipper and less problem and time than replacing crankshaft and oil pump with bearings main and connecting
...oil filter, make shure its tight,,, good luck There is an opening on the top of your timing cover sealed off with a rubber plug. Remove the plug to gain sightful access to inside your timing. But ...
...oil filter..i hope this helps They could be the same and if the contact point for the crankshaft is the same as the 2000, then the sensor is sending the signal to the module about 180 degrees off. ...
crankshaft. Put cap in place and snug bolts. Torque bolts to spec. Main Bearing Cap: 8mm bolts- 25 ft/lb, 11mm bolts- 60 ft/lb Replace oil pan and all parts removed in reverse order. Put drain plug in
...oil on the four spark plugs of a 2000 dodge neon. What would cause this? if there is oil on the plugs you might need valve stem seals or rings in the engine I just changed the valve cover gasket and ...
...leak when oil seal broken or some looseness in engine and it,s need to replace oil seal. it,s up to you repair by yourself or take help from a mechanic. hope answer the question thank you please
crankshaft main seal i replaced the crankshaft main seal, after dropping the transmission and after putting it back in, the flywheel gets locked up and won't move make sure the flywheel is not
replace the Front Main Seal I need to know if it is just the one seal and is it the one that goes to the Oil Pump? There isn't any other seals for the Front crankshaft? It on a 2.4L 2000 Plymouth Neon
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions