...replace the screws. 3) Ensure that the Ready Tools knob (diverter knob) is in the proper setting and the valve opens and closes freely. Ensure the black foam gasket is in place under the valve. 4) ...
...replace the screws. 3) Ensure that the Ready Tools knob (diverter knob) is in the proper setting and the valve opens and closes freely. Ensure the black foam gasket is in place under the valve. 4) ...
Question about ProHeat Turbo Deep Cleaner Upright Steam Vacuum
...replace the screws. 3) Ensure that the Ready Tools knob (diverter knob) is in the proper setting and the valve opens and closes freely. Ensure the black foam gasket is in place under the valve. 4) ...
Question about 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum
...replace the screws. 3) Ensure that the Ready Tools knob (diverter knob) is in the proper setting and the valve opens and closes freely. Ensure the black foam gasket is in place under the valve. 4) ...
Question about Carpet Cleaner Powerbrush Deep Cleaner Vacuum
...replace the screws. 3) Ensure that the Ready Tools knob (diverter knob) is in the proper setting and the valve opens and closes freely. Ensure the black foam gasket is in place under the valve. 4) ...
Question about Nano Cyclonic Compact Bagless Upright Vacuum, UH20020/W
Baffle tube can be rinsed if needed. Allow to dry thoroughly. 7. Remove the hose from both ends. Use a broom stick to loosen and remove any clogs from the main hose. 8. Remove the bottom plate and the
...take up to an hour. Overheating is usually caused by a clog or a filter that needs to be cleaned or replaced. Below are simple instructions for checking your vacuum for clogs. 1. Remove the dirt cup. ...
Question about Nano Cyclonic Compact Bagless Upright Vacuum, UH20020/W
...vacuum has lost suction. This is caused by either a clog or a filter that needs to be cleaned or replaced. Please try these brief trouble-shooting steps. 1. Remove the dirt cup. Twist off the dirt ...
Question about Nano Cyclonic Compact Bagless Upright Vacuum, UH20020/W
...can be rinsed if needed. Allow to dry thoroughly. If the filters are too dirty they may need to be replaced. With regular maintenance the filters should be replaced about once a year. Follow the ...
...Replace the baffle tube. 4. Remove the filter from vacuum base. Hold filter under running water to rinse. Allow 24 hours to air dry before replacing. Hope this helps get your vacuum back up and ...
Usually answered in minutes!
1,132 Questions
1,137 Questions
870 Questions
836 Questions
