Questions & Answers for: Velodyne replace 80 amp fuse

...fuse or the amp or the driver... however by doing this you risk blowing up the second working amp or voiding warranty. Last year I had an amp failure on my velodyne and it cost 250 for a 2007 ...

...amp and connect a sub cable to this and next to the LFE or phono type input on the back of the sub ,if it has two inputs left and right pick the left side ,set the cross over to suit your system and ...

Subwoofer will not work when connected I have connected the subwoofer to the pre-amp out on the back of my dolby 5.1 receiver. The subwoofer has worked for a few years but now is not working. The ...

...CT 80 powered subwoofer does not power on? Velodyne CT 80 powered subwoofer with 8" subwoofer Fuse in amp may be blown or the amp is dead Contact Velodyne, the replacment amp is not very ...

fuse keeps burning out. check he amps on the fuze itself make sure your using the right amp fuse and another thing you have capcitors that can over load and cause your fuse to keep frying

...amp has a fuse mounted on the PC board. The fuse may be blown. The speaker may be bad. that may have blown the fuse. You can test the speaker with a "D" battery. Take the amp section out of the back, ...

My subwoofer keeps poping and then stops working larryagross, Sounds like you blew the speaker! The amp is sensing the voice coil is connecting to the speakers magnet or iron core and is going into a ...

...80 w @100volts to the same amp. please let me know the procedure and the method for connecting the subwoofer. Here's a diagram let me know if you need ...

where is fuse in velodyne dps-12 Just a guess, but the drawing in the manual shows a fuse rating of 2 amps where the power cord enters the box. Is this a combination fuse/connector. Have you looked if

Need the Velodyne VX-11 fuse location & type ¿? Already answered for DPS-12 in 2011 which suggests a fuse where the power enters, However, your manual mentions no fuse, but 'protection circuitry'. If ...