Questions & Answers for: PPI replace 80 amp fuse

Question about DCX-1500.1 Car Audio Amplifier

2 Answers

80 amp fuses when the amp turns on. I have disconnected subs, RCA's, and just have 4 gauge for power, 2 (or dual) 8 gauge for ground, and a remote turn on connected. If I disconnect the remote turn on

Ad

Question about PCX-2200 Car Audio Amplifier

1 Answer

problem in ppi pcx-2400 my amp powers on and the led light turns to green like always but i am not getting any sound from my subs i checked the wiring and nothing is dissconnected. It was weird ...

Ad

Question about PC2600 Car Audio Amplifier

1 Answer

amp up, the fuse blows. What gives?.... If the fuse only blows after the remote voltage is applied, the output transistors are likely shorted. To eliminate the speakers as a possible fault, disconnect

Question about PC1400 Car Audio Amplifier

2 Answers

...will add as much as $100 to the repair bill. i ran into the same problem. check you GAIN setting on the left side of the amp. i have also changed my power cable so i could boost up the fuse the an

Question about PPI2360 Car Audio Amplifier

1 Answer

...80 amp fuse up front....Im thinking that might have something to do with it but not sure. Please help! Thanks the bridge rectifier is most likley shorted in the amp.you could repair yourself if you ...

Question about PPI2360 Car Audio Amplifier

1 Answer

...than the other which then in turn wil blow. I would go for either a 40 amp single fuse made for something other than a car situation and place that in the power line or get a 12v circuit ...

Question about PrecisionPower D1000/1 Subwoofer Mono Amp - 185W Class D 495W RMS @ 1 Ohm Q BASS Plus Optimization... Car Audio Amplifier

1 Answer

i got a ppi d1000/1 amp cant get any sound out of it? Make sure your remote wire is hooked up in the right spot, also check your rca plugs and consider replacing them, check all fuses to make sure ...

Question about PC2600 Car Audio Amplifier

1 Answer

...amp and now the inline fuse by the battery keeps blowing Most likely you have your power and ground connections reversed on the amp. That will cause the fuse to blow immediately upon contacting the ...

Question about PCX-480 Car Audio Amplifier

1 Answer

I HAVE A PPI PCX 2200 THAT IS NOT GETTING ANY POWER AT ALL I CHECKED ALL FUSES STILL NO POWER 1.verify connections...Make sure your ground wire is grounded to a location on the body where you will ...

Question about D500/1 Car Amp

1 Answer

i have a Precision Power D500/1 amp n i cannot get it to power up i have good power from the battery and good ground and my remote wire is hooked up but still no power Check the fuses. There might be ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top PPI Car Audio and Video Experts

xxxxxx xxx

Level 3 Expert

5117 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a PPI Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...