Question about Pmp3000 16 Channel Audio Mixer
...amp and it wont cause the fuse was blown. replaced it with the same fuse 250v 6.3A and turn it on again and a burn smell came out of it. i turned it of, cheked the fuse, the fuse was ok but the unit ...
Question about EUROPOWER EP2500 Amplifier
...replace, I don't understand the 15- and 15+ voltage others have been mentioning on other solutions. Both fuses inside the amp are not broken (checked with multimeter). I have the schematic for the ...
Question about Bx4500h Ultrabass 450w Bass Amplifier
...Amp doesn't come one. it shutdown after it was used. There are three entries for this same device. If you have overposted these, the symptoms combining the three would indicate that one of the power ...
Question about Xenyx 1002fx Mixer 10 Input 2 Bus with Efx
...amp fuse did not last - 10 amp is standard > is it time to trash this unit? I don't understand because the Xenyx 1002fx draws only 16 Watts so the fuse should be well less than 1 amp why would you ...
Question about Pmp3000 16 Channel Audio Mixer
replace those taken out. Each side of the amp will likely take out 3 switching MOSFET transistors and often a Zener diode. Sometimes a low resistance metering resistor will be fried with smoky residue
replace all the back casing for the amp and power. Where can I find this part, or can I replace with the newer b215d? Were the fuses blown when you took them out? Did it blow the new fuses too? If so,
...replace a fuse that protected the power supply and that blows the power supply taking out another $30 of components and $200 labor. (they are hard to change) If the unit is under warranty, exercise ...
i have a fender 80 combo amp and a digitec multi effect pedal for bass, what is the best way to hook these up ? guitar to pedal then to the amp
Question about Pmp3000 16 Channel Audio Mixer
...amp from a friend. Where can I find the cap that holds the fuse in, and what fuse do I replace it with?villaslasolas You are in big trouble! You will wait months to get the part from Behringer. Here ...
Question about Europort Epa300 300w 6-channel Portable Pa System
...at the back of the amp so getting no power.i have changed the fuses, the power supply uses 2 x mosfet spa11n80 they are burnt out replace them. unit start at 80 volts ac use veriac if you have ...
Usually answered in minutes!
192 Questions
108 Questions
85 Questions
69 Questions