gear wont open I am overhauling the engine block of my hyusang GT250. While trying to disassemble the gear, i cannot pull the "second drive gear" off the shaft. Does the "counter shaft bush" inside ...
2007 Hyosung GT250R stalling in 1st It starts fine, runs in neutral fine and can rev up. As soon as it goes into first and I release the clutch out of the friction zone it stalls. I've replaced the ...
the signal light on one side dont work burnt out bulb or you need to replace the flasher unit.
...Worn or broken bearings.2. Big-end bearings worn and broken.3. Thrust clearance too large.Adjust.Replace.Replace.Replace.Replace.Replace.Replace.Replace.Replace.Repair or ...
BROKEN CRANK SHAFT repair will not do any good, have the part replaced
...fuel gauge has one bar left on the digital read out and it is flashing. however it is full of fuel. Replace or check the fuel sensor in the tank. It may indeed just be a wire either broken or ...
...with this problem is that there is a small hole in the pump diaphragm and the pump should be replaced. Another thought is, that hole is there to equalize atmospheric pressure and it could be ...
hyo gt250 comet: i am replacing gearbox oil, how do i know when enough is in? and does it go in the screw hole up top or the screw on the side? There should be on top of either the left or the right ...
i replaced the fuel tank on my 2007 hyosung 250. now i dont know where the hoses go. i need a diagram. The hoses are all different diameters and only fit on the nipples that are the same size. Don't ...
Question about 2005 GT 250
Hey I recently just replaced my gear lever for my 2005 hyosung gt250r and upon replacing I had troubles with shifting into neutral while the engine was running from 1st gear. I've tried shifting from ...
Usually answered in minutes!
87 Questions
5 Questions
2 Questions
0 Questions
2 Questions
