Questions & Answers for: repair projector fan

projector is trying to expell. easiest way to repair the fan w/o buying a part: splice the fan wires together. they can share voltage. if the 80mm fan does not work at all after that, replace the fan

...fan failure and the fan does stop turning Lubeor replace the fan.If you cannot do this, take it to a repair shop.The fan is monitored because without it the projector will melt down a la china ...

...projector. If it died due to heat expansion, (i.e, the motor binds and stops) you can't repair it. Sometimes, if the computer signal is gone, you can open up the motor and replace a bad ...

...projector lamp is not working and causes the unit to overheat. Is there a replacement for the fan and housing? you'll need to find an epson authorized service center from the epson site. you can ask ...

...Locked - Projector will be shutdown - Call service for repair. But Fan is working good !! Does any one know why ? there must be a fan sensor defective or dirty. must change fan to same fan model

projector turns on but says fan failure any ideas on how to fix this problem Yes. You will have to find out which of the many fans has failed. I reckon it will be the fan neaest the lamp. Clean the ...

...repair is pretty much a total tear-down of the projector. Unless you have been in a projector before (and have a service manual), you may cause more harm. I would recommend finding a factory-trained ...

...projector had a fan overheating problem. Took it to a repair shop. They opened it up and found that the blades were broken. They tried to get a new fan but Optoma refuse to supply them. Do you know ...

...fans are not working. Anything I can do, clean etc to fix myself? Or is this dead? If it has to be repaired is it usually cheaper to buy new unit or have the old unit repaired? If the lamp exploded, ...

...projector fell then said one fan was not working, will turn off in a minute, and it did, now how do I fix the fan, get a fan part where and how? How much do repairs liek this cost? how hard are they? ...