Questions & Answers for: Hyundai Santa Fe removing

Question about 2007 Santa Fe Limited

1 Answer

trany lube pump removal of trany cover pan Remove the screws/bolts and carefull pry the pan off, it will make a huge mess, the best way is a plastic trash can lid with holes in it to catch the fluid.

Ad

Question about 2007 Santa Fe Limited

1 Answer

way along to the ignition switch. You must use plastic pry tools to free the clips and to prevent damage to the dash. By removing this trim piece , you will gain access to 4screws to remove the centre

Ad

How do I remove the engine out of my 03 Hyundai Sants Fe. I have all of the bell-housing bolts out except one. It is on the back lower side of the engine. It goes in the opposite way as the others but

...removing wires and hoses until they are all out of way of cover. Then remove the bolts all way around cover and pull straight up and it will come right off. If not use a flat head screw driver to ...

We have a 2004 Hyundai Santa Fe where the windshield washer pump won't spray water on the windshield. We have checked the fuses, blew air through the hose- seems fine and the holes do not seem clogged

...but not ball joint. I will use ball joint removal tool That's the right way and only way to do this, just put some lube on the fork side, that will slide on the ball joint boot when removing

engine removal v6 santa fe,is it possable to remove the engine up and out once the radiator is out and axles disconnected the only way is up and out.its also easier if you take off the front cross ...

how to remove door panel from hyundai santa fe A door panel removal tool works best, but if you have a stiff putty knife about 4" long and 1 1/4" wide it will work if you are careful. Start at the ...

how do we change the rear brakes shoes that are behind the rotor on my 2002 santa fe remove tire remove caliper and pads with two bolts and adj emergency brake off all the way or untill rotor will ...

Question about 2002 Santa Fe

1 Answer

starter removal remove battery terminals to prevent unexpected grounding of wires at starter. Remove wires at starter, taking note of how they are placed on the starter/selonoid... remove starter ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...