Questions & Answers for: removing engine 1993 gmc sierra

...1993 GMC Sierra 1500 with a 4.3 V6. Problem: the heat gauge on the dash does not show the engine is heating properly, only goes to lowest heat (100 degrees). I've replaced the thermostat (original) ...

gmc sierra 2500 1996 No star engine, no have inyection. need more info on motor is it carberated / tbi check for spark at plugs for good spark 3 thing to a motoor to run fuel spark an compression i ...

...GMC 5.3 liter truck. with under 60k on it. about a month ago I had to have the hydraulic lifters replaced on the drivers side head. I just noticed it was knocking again, same side, and I also noticed ...

engine won't idle, 1993 GMC Sierra 4.l V6, TBI. Service engine light comes on. Code 12 on diagnostic. The engine will not stay running when cold and the truck lurches when accelerating. I changed the ...

...1993 6.5 L diesel engine Twist the black ring CCW and remove.Then pull up on filter.Most have a little plastic tab.They usualy break off.Then install the new one.You may want to try and inspect the ...

...removing the manifold? Truck is a 1993 GMC Sierra 1500 5.7 engine 2-wheel drive. I see this problem fairly often and you can get the fitting out but you need a bit of patience to do so. I remove ...

removing all of the old gasket from the housing and the block.You should only do any of this after the engine cools and you have relieved the pressure,removed the rad cap.The water pump requires a bit

gmc sierra 3500 diesel 6.5 and whear is located?? FUEL FILTER MOUNTED ON A BRACKET TO THE REAR OF THE INTAKE MANIFOLD.TO REMOVE FUEL FILTER.TURN OFF IGNITION.RELEASE ANY PRESSURE OR VACUUM IN THE TANK

engine running ruff ,engine misfiring even after plug change ,wires changed rotor and distributor check the map sen check for vacuum and check to see if at idle if removed vacuum from the map sens Eng

...1993 gmc Sierra still doing the same thing any suggestions Check that the EGR vacuum solenoid is working. Remove the vacuum line to the EGR and there should be no vacuum in that line with the engine ...