Questions & Answers for: Chevrolet Blazer removing axle

Rear Axle Removal Hi, we need to remove the rear axle to replace outer seal. Thanks if you are talking about the axle seals, 1.REMOVE THE WHEELS.2. REMOVE THE DIFF COVER(slowly)3.REMOVE THE BRAKE ...

Rear axle removal I need to remove the rear axle from a 1999 Chevy Blazer ..... Where do I start? Do you have a diagram to help me? Remove wheel, remove rear diff cover, remove small bolt that retains

...is a c shaped key on end of axle where u took spider axle rod out remove this key easly by hand and pull axle out,,,note do not turn chunk after removing spider axle rod or ur spiders will fall ...

removing axle from 2000 chevy blazer my manual says to remove the pinion shaft to get to the c locks on the axles, but i can't get the pinion shaft out. any tricks? unbolt set bolt than slide out of ...

gear shaft retaining bolt, then the shaft. Then, after removing the wheel, tire and brake drum, push in on the axle to allow the c clip to fall off the end of the axle, then the axle can be pulled out

Replacing front hub assembly remove the wheel, then remove the caliper and tie of to the side, slide rotor off, remove the axle nut, remove the lower balljiont nut, use a balljoint sperater tool to ...

...removing the U-bolts to keep the axle from suddenly dislodging. Remove the rear wheels and drums for clearance and to remove some weight from the axle housing. If equipped, remove the axle vibration ...

I'm trying to remove the rear axle off of my 1996 checy s-10 blazer 4x4. Does anyone know how to remove this axle??? Just the axle or the housing?

how do i remove the rear axle shalfs from my 2000 chevy blazer s10 you have to remove the cover then spin the carrier assembly by spinning drive shaft un till you see a mall bolt that will hold the ...

take rear axle out need to replace carrier how do i get axles out Remove the carrier center pin (usually held in by a 1/4 inch diamenter bolt), then, push the axle in about 1/4 of an inch. This will ...