Questions & Answers for: Troy remove trimmer head

...Trimmer Manual needed. I installed GrassGator trimming blades in head and cannot figure out how to remove head to install new blades a lot of times there is a hole in the side of the head to insert a ...

...remove the outer cup of the trimmer head. Any help would be greatly appreciated. Thanks! There is a round, rotary black part between the metal piece to which the cutting head attaches and the outer ...

remove the trimmer head from shaft How do you remove the trimmer head from shaft to replace with a shakespeare fast loader? The entire trimmer assembly (from the gearbox forward) will slide off of the

...remove a trimmer head on a tb514cs how do you do this it if has a bent drive shaft the head removes by undoing it RH (anti clock wise) if it has a straght shaft with a gear head at the line end, it ...

...trimmer head to remove the head from the lower shaft. After the head is off you can look down into where the shaft goes and be able to use some needlenose pliers or something of the sort to pull the ...

...trimmer head. Attempted to hold the shaft/rod, but it twisted and I thought it might break. I used a needle nose vise-pliers to clamp onto and hold head, at top of factory head. [At bottom of ...

...remove the cutting head from a troy-bilt tb525 ec 4 cycle gas trimmer? ref: removing cutting head from troy-built trimmer tb525... Just talked with Troy-Bilt company and got answer on how to remove ...

trimmer but can't remove the black inner spool. Any suggestions? Unscrew the head's center bump-knob counterclockwise with your fingers. Pull the bump knob off and take the spool cover off the

...trimmer runs well, but when I give it gas, the engine revs up but the head does not spin. What/how do I repair? Remove the angle drive gearbox near the string head and spin it to see if everything is ...

...remove the trimmer head from my TB32EC Troy Bilt trimmer to clear grass build up inside of plastic head? Depending on the style of head, you either unscrew the cap on the end. of you push 2 clips in ...