...or screwdriver approx 4" in at each side to release the clips (one at each side). this will allow you to lift the top and then remove the two front panel fixing bolts 7-8mm to remove the front
...remove the front panel to gain access to the pump, To do this insery a flat knife between the top panel and the front panel 4" in from each side to release the clips. Unclip the two hoses to the pump ...
...in to spin cycle the water come out the top over flow. It dosn't mater what water level you but it on..Carmon Probably the pump or filter is blocked, remove the pump and filter and remove any ...
washer my admiral washer leaks on the bottom when it spends.What's the problem? Sounds like the top seals are worn, drum needs to be removed to replace top seals (2 off), job for skilled person.
top of the tub. Any solutions? Purchased washer 11/02. Remove the control console cover. Find the water level switch. It has a small tube attached to it. Remove the tube and blow air through it. It is
...remove the front panel. How do I do this? Isolate the machine, use a knife or thin bladed tool and insert between the front panel and the top panel approx 4" from each side to release the clips, the ...
...I can fix? Sounds like the belt is broken. Yes you can fix yourself. Lift top, remove front cover, belt is at bottom, not to hard to replace. If belt is not broke let me know, I will go
...top meets the front. About 2 inches in from each side are 2 clips that must be pressed inward to raise the lid. Once the lid is raised,remove the 2 wires from the lid switch and jump them together ...
remove agitator on an admiral 6005 top loader How do I remove agitator on an admiral 6005 top loader? GUIDE
...top loader It only happens during the spin cycle and when I looke at the back of the washer it almost looks like the basket is hitting the back of the washer and hence the hammering sound. The washer ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions