...of the motor can be turned mannually with an allen wrench which will assist in closing and identifying the problem area.If its hung very badly ...remove the sunroof motor then push the roof
...sunroof. Fig. Remove the trim panel to access the sunroof motor Fig. Insert the 6mm hex tool from the tool kit and turn the hex socket to close the sunroof Removal & Installation E30 Models Fig. ...
...Sunroof motor with the limit switches • Sunroof switch • Sunroof glass-spoiler type, with glass sliding above roof • Sunshade • Rail and track assembly upon which the sunroof glass rides • Power ...
...sunroof motor bolts. Remove the motor and you'll probably see that the cable is damaged. Use a pair of wire cutters and cut it out of the way and then feed the cable back into the groove/slot( you'll ...
...REMOVE THE SUNROOF MOTOR UNLESS THE SUNROOF IS COMPLETELY CLOSED.OTHERWISE A NEW MOTOR WILL HAVE TO BE INSTALLED AND TIMED WITH A TOOL THAT COMES WITH THE NEW MOTOR.THE GLASS PANEL CAN BE ...
...Remove the sunroof switch panel by pushing it to the side and disengaging the pawl, then pulling it downward. Fig. 1: The sunroof switch panel is retained by a metal clip Remove the sunroof switch ...
Question about 1999 Grand Prix
...Remove the sunroof window. Refer to Sunroof Glass Panel Replacement . Slide the sunshade fully rearward. Move the sunroof window to the vent position. Remove the sunroof screws (two on each side). ...
Question about 1999 Grand Prix
...sunroof track assembly. Remove 2 torx bolts from each cover plate. Lift up bracket to remove. Inspect the plastic guides on each side. The sunroof cables attach to guides on front outer corner. ...
Question about 1999 Grand Cherokee Limited
...Installation for proper procedures. Disconnect the drive motor wire harness connectors (Sunroof Drive Motor and Express Module). Remove drive motor fasteners and remove motor from the sunroof ...
Question about 1999 Grand Cherokee Limited
...sunroof motor...where is that? 2003 Pontiac Grand am First off this is controlled by a module (computer) The switch would only have five volts . 5volt reference voltage from the control module . Not ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
