Questions & Answers for: how to remove relay

...Remove the relay by depressing the bracket clip at the rear of the relay, or removing the bolts from the retaining bracket, as applicable. If necessary, use a new relay, then reverse the removal ...

...High beam relay 3. park lamp relay 4. internal under dash relay Number 13 when all the relays are removed (not sure if it was just one that stopped the sezure or the removal of all. but didnt stop ...

...relay switch wiring. Remove the protective cover. Disconnect the push-on electrical connector. Remove the nuts. Remove the cable. Remove the starter motor solenoid relay switch (11450). Remove the ...

...relay. Remove the nut and disconnect the cable from the starter side of the relay. Fig. Fig. 12: Remove the relay-to-fender apron attaching screws ... Fig. Fig. 13: ... then remove the relay from the ...

...was dead. I found that a relay under the dash in the fuse panel was the source of the clicking and removed removed it. Clicking stopped. Replaced the relay and the clicking began again. Removed the ...

...housing. Remove the left headlamp module. Remove the cover over the relay. Disconnect the relay connector Radiator Fan Relay Carefully drill out the two retaining rivets. Remove relay from

...reservoir. Disconnect electrical connector at relay (Radiator Cooling Fan Relay Removal/Installation). Remove 2 relay mounting bolts (Radiator Cooling Fan Relay Removal/Installation) and remove

...under hood just below the coolant reservoir. remove nut and ground (not required but makes removal easier). remove the 2 bolts. pull the relay down and remove 2 plugs from the bottom of the

...Remove circuit opening relay with wiring from bracket. Insert voltmeter positive probe into rear of connector at Fp terminal. Meter should read battery voltage during cranking and while engine is ...

...relay. Step 5: Remove the electrical harnesses. Step 6: Remove the ignition relay. Step 7: Reinstall the new ignition relay. Step 8: Reconnect the battery terminals. Step 9: Clear error codes with a ...