Questions & Answers for: remove rear seat gmc sierra

...rear axel bearing on 4x4 5.3 Litre gas engine 2000 GMC Sierra 1500 Loosen differential cover and let oil drain. Remove cover, remove U lock from axel. Pull axel out. Remove bearing seal then bearing. ...

Ad

...remove rear view mirror, and cut the glass out, trim existing urethane down leaving a thin layer (1/16") to apply your new urethane adhesive to. prime any nicks to the pinchweld to protect from ...

Ad

remove? You shouldn't have to. Once you have the hub off the truck they will come out with a sharp rap with a good sized hammer. When you put the new ones in, try to line the grooves up as best as you

Question about 2006 Sierra 1500 2WD

1 Answer

...rear diff yoke? Hi, there is no real torque spec., as the pinion gets tightened against a crush collar, creating a preload for the pinion, as the preload is tightened to 20-25 lbin, on a rotational ...

Question about 2006 Sierra 1500 2WD

1 Answer

Remove all engine oil pan fasteners except two nuts at rear of engine. Separate the engine oil pan from the front cover. Disconnect the crankshaft position (CKP) sensor wire. Remove engine front cover

remove the seat cushion and replace it or the seat back cushion the heaters are intergrated into the foam the seat cushion unbolts with two fifteen millimeter nuts just under the front of the seat and

rear seal, remove the drive shaft, and the seal should be very visible there. Very fortunate, as this is the easiest and cheapest seal there is to replace! Be extremely careful installing the new one,

how to get seatbelt unhooked from post on the cab i want to check the drivers side rear speaker and cant figure how to remove the seat-belt mounted to the cab post. T-50 Socket (TORX)

...crimping the end of the stud and then pull to check movement sometimes the bolts on the inside of the seat come loose for the back rest and need tightened. Remove the rear headrests from seat ...

...rear seal you can just drop the drive shaft and then same as the front. Take a small flat head screw driver and remove the old one and then dry it off and clean it as clean as possible. Place the new ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...