Questions & Answers for: GMC Jimmy how to remove pin

Question about 1998 Jimmy

2 Answers

...REMOVE PIN. PUSH BOTH AXLES INWARD. LOOK INTO CENTER OF CARRIER WHERE AXLES MERGE. EACH AXLE WILL HAVE A RETAING CIRCLIP. REMOVE EACH CLIP & PULL AXLE OUT ABOUT 1 FOOT. REMOVE REAR DRIVESHAFT & SHAFT ...

Ad

Question about 1998 Jimmy

1 Answer

...remove cotter pin out of nut for tie rod end then remove nut. 4) loosen tie rod end from knuckle donot split greese boot or hit top of stud as this will damage it.5)remove axle nut and push back axle ...

Ad

Question about 1997 Jimmy

1 Answer

...remove the hinge pins, use a brass punch and a hammer, and tap down on the end of the pin until it is flush with the top bushing. Do the same for the bottom one(I think you tap up on that one if I ...

Question about 1998 Jimmy

2 Answers

...to replace , may be able to get new bushing and pins , without replacing hinges If door hinge has removeable pins and bushings replace them, otherwise replace hinge. Also you might jimmy it by ...

Question about 2000 Jimmy

1 Answer

...pin in place. Remove that bolt. Slide the center pin out, BUT DON'T TURN THE AXLE SHAFTS WHILE ITS OUT! Push the axle shaft in from the outer portion (where the wheel goes). A "C" clip will fall out ...

...remove this also.Now, once the dowel pin has been removed, looking for a **** in the ignition housing. Take chisel and insert into this ****, drive the chisel into the **** until the ignition housing ...

Question about 2000 Jimmy

1 Answer

...of the carrierer rotate the carier untill u see a 8mm bolt on the pass side through the pin remove the bolt slide the pin out push the axles in and remove the u shaped clips and slide the axles ...

Question about 2000 Jimmy

1 Answer

...one pin at a time - for the upper pin, compress and remove the small spring, drive out the old pin, drive in the new pin and put the spring back. No spring on the bottom hinge - just replace the

...remove the wiper motor and the wiper assembly must be removed first If you mean the blade itself and not the whole arm, do you have the original Pin type where it looks like a Pin pushed into a whole ...

pin is lined up with hole on both and lens falls out so keep a hold of it ----or you have the 2 long skinny bolts down to the lens unscrew them and pull lens forward from truck remove connector and to

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2000 GMC Jimmy
2000 GMC Jimmy

1,363 Questions

1997 GMC Jimmy
1997 GMC Jimmy

1,123 Questions

1998 GMC Jimmy
1998 GMC Jimmy

1,127 Questions

1999 GMC Jimmy
1999 GMC Jimmy

1,104 Questions

2001 GMC Jimmy
2001 GMC Jimmy

838 Questions

Manuals & User Guides

Loading...