Questions & Answers for: Chevrolet Malibu how to remove pin

Question about 1998 Malibu

3 Answers

...pin. the only thing i will sugets is to remove the dash board and return the neddle by hand most of times it will bering it back to normal operation I HAD SAME PROBLEM.SOLUTION.TAKE PAPER CLIP INSERT ...

Ad

...assembly , there are 2 plastic slide pins one on each side. pull up on these slide pins to remove headlight assembly. then you can replace the bulbs. when putting back on , push in on ...

Ad

...remove the pin and the vehicle guide says I should only need to press down on the center clip. I did press the clip and it didn't come off so I think its the pin holding it in but I'm not sure how to ...

pin connectors. Now remove and replace with new unit. I did notice the steel pin that operates the horn(it pushes in and out and sits against a rotating plate in front of the steering wheel) was a bit

...remove the pin from the door panel . With the pin out of the door panel push the center pin back out of the push pin retainer so it will be ready to go back in)Then remove the screw cover behind the ...

...for a 2004 Malibu the horn is easiest to access by removing the right front headlight assembly. to remove headlight assembly, there are to plastic slide pins, just pull up on these to remove

where is the horn located on a 2000 chevy malibu the horn is under passengers side headlight. remove headlight assembly then you can see it. to remove assembly, pull up the 2 plastic slide pins, that ...

Question about 1999 Malibu

1 Answer

...remove the gauge pin. If installing a new switch, proceed as follows: Place the shift shaft/control lever in N . Align the flats of the shift shaft to the flats in the switch, then install the switch ...

Question about 2004 Malibu

1 Answer

...remove. Personaly this design is one of my favorites. No special tools are needed to release the connections.***After the tank is slowly lowered onto the floor then you can start removing the sending ...

a chevy. Malibu 2003 3.1 engine and how to program the Remove covers and there should be a little pin you push in which allows the barrel and keys to come out.( use a piece of wire to hold the pin in)

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...