Questions & Answers for: remove lamp

Question about 50V715 50" Rear Projection HDTV-Ready Television

1 Answer

...Remove the lamp unit by holding the lamp handle, then pulling outwards. Exercise caution when removing the lamp unit to avoid injury to your fingers Replace with the new lamp. Place the removed lamp ...

Ad

...lamp. Remove the wingnuts from the tail lamp. Remove the tail lamp from the rear body panel. Disconnect the electrical connector from the tail lamp. Remove the tail lamp socket, turning ...

Ad

...remove the lamp assembly to replace the bulb. here is the procedure: Rear Lamp Assembly ?Sable Four Door Removal and Installation Remove the luggage compartment scuff plate. Pull back the luggage ...

...Remove lamp from bumper. Remove bulb socket from lamp. Pull bulb from socket. INSTALLATION Install bulb into socket. Install bulb socket into lamp. Place lamp in position. Install screws attaching ...

lamp (7) 5. Remove the following from the tail lamp: - The stop lamp socket (2) - The turn signal lamp socket (5) 6. Remove the following from the lamp sockets, if necessary: - The stop lamp bulb (1)

Question about P52939 52" Rear Projection Television

1 Answer

Remove Lamp Compartment Door. The lamp compartment on projectors islocated underneath the projector unit. For Rear Projection TVs, the lamp compartment is located in the rear bottom left or right side

Question about P52939 52" Rear Projection Television

1 Answer

...remove the old lamp and insert the new one. Put the glass back, securing it with the ring. c) Biax neon lamps: G23 11W lamp. Once the fixture has been removed, remove the biax lamp from its seat and ...

Question about 2004 Envoy

1 Answer

...Remove: Tail lamp assembly removal and installation Remove the tail lamp assembly retaining screws from the body. Release the locking pins by pulling the assembly directly rearward. Disconnect the ...

...Remove the LAMP COVER. • Remove the BODY COVER. • Remove the BODY BRACKET. • Remove the MAIN UNIT. (1) Remove the 2 screws [H]. (2) Remove the LAMP BALLAST DUCT. (3) Remove the 2 screws [I]. (4) ...

...Remove the tail lamp and side marker lamp sockets from the tail lamp, depressing the locking tab and turning counterclockwise. 6. Remove the bulbs from the tail lamp and the side marker lamp sockets, ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Televison & Video Experts

Grand Canyon Tech
Grand Canyon Tech

Level 3 Expert

3867 Answers

Cindy Wells

Level 3 Expert

6688 Answers

 Grubhead
Grubhead

Level 3 Expert

5755 Answers

Are you a Televison & Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...