Question about 5 Hp 230 Volt 2 Speed Side Discharge Spa / Hot Tub Pump 2" Plumbing # S50230
How do you remove the impeller from a Waterway Executive 48 spa pump Take off the back of the motor, put a wrench on the shaft and turn the impeller by hand to loosen. It may be reverse threaded.
Question about Spa Pump Executive 56 Frame 4hp Dual Speed 2" Intake 2" Discharge
...remove impeller The impeller in my 4 HP, 2-speed Waterway Executive High Performance 56 pool & spa pump has a brass coupling embedded in the back side. This coupling can be unscrewed from the ...
Question about Dream Series Dream Master Hot Tub with Flex Cover
the pump runs but the water is not flowing in my Oasis spa tub Your impeller has spun the center out of it. Remove the pump and replace the impeller.
Question about Executive Spa Pump 4hp Impeller 3104190
remove the impeller on a 4hp Speck pump...I've worked on several 3/4 to 3 hp pool pumps but this one is a first...also, how is the seal plate attached? maybe I'll figure that out if I'm able to remove
Question about Pool Pump Motor Hayward Swimming Pool Pump Full Rated Motor / Cen
how to remove impeller case from century centurion pump case surrounding impeller needs to be replaced take out screw to impeller backwards thread impeller unscrews normally
Question about Pool Pump Motor Hayward Swimming Pool Pump Full Rated Motor / Cen
...remove impeller on Pentair ultra-flow pump My pump is leaking so I want to change the seals. therefore I have to remove the impeller. I hold the motor shaft with a flat screw driver but I ...
Question about 5HP Executive 56 Frame Spa Pump PF502N22C
remove impeller from Waterway 502n22c How do I remove an impeller from a Waterway pf502n22c executive 56 frame spa pump? To remove the impeller you first take the front face plate off to expose the ...
...Impeller and remove it 4) Next, inspect the Pump Motor Impeller itself. (This is a high suspect part). See if there is any sign of wear or breakage. (This happens over time from debris in the water ...
...Impeller and remove it 4) Next, inspect the Pump Motor Impeller itself. (This is a high suspect part). See if there is any sign of wear or breakage. (This happens over time from debris in the water ...
the impeller to the shaft. Alternately, the impeller may be screwed on to the end of the shaft.Remove the impeller and seal from the shaft.Inspect and replace the impeller and seal.Reassemble the pump
Usually answered in minutes!
1,045 Questions
774 Questions
337 Questions
287 Questions