Questions & Answers for: remove ignition switch 1996 dodge

Question about 1996 Ram

1 Answer

ignition switch. NOTE: Be sure to remove the connector and check to see if it is melted and burnt if it is you will need to get a pigtail from chrysler to replace the bad one and of course an ignition

Ad

...ignition switch. Battery is good shows 13amps when checked. battery and starter connections are both good. when i turn the key to start all the cluster lights appear and you can hear the starter ...

Ad

...ignition switch to on position, remove oil pressure sensor pin and touch it to engine body where it should get earthing, and same time oil light should come on, if it is not then that wire is ...

...ignition switch, spark plugs, plug wires, throttle position sensor, replaced cracked vacuum hoses, and an oil change less than 100 miles ago. I had advanced auto run the obd2 computer check, and it ...

Question about 1996 Neon

1 Answer

ignition coil and fuel filter. Am currently looking for a new fuel filter. Problem two: My dome light is now staying on and will not shut off. for your dome light, one of the door switches is shorted,

...ignition and turned to start point nothing comes on and theres no sound from engine or starter. The battery is in good condition. The fuses by the steering wheel and under the hood seem to be in good ...

remove the ignition so it can be replaced Cirrus, Stratus, Sebring Convertible and Breeze CAUTION The Supplemental Inflatable Restraint (SIR) system must be disarmed before working around the steering

...removing the keys the head lights and rear lights stays on. Head lights and rear lights run on a separate power line than the ignition switch. Those are on a manual switch always allowed power

ignition switch also. IF SLAPPING THE DASH WORKS, THE PROBLEM IS MOST LIKLEY A BURNED WIRE CONNECTION IN THE INSTRUMENT PANEL WIRING, YOU WILL HAVE TO REMOVE THE CLUSTER AND DISSAMBLE TO REPAIR BROKEN

ignition switch area or elsewhere. it was on the smaller post. That other wire went to the oil pan BOLT and to the BRACE???? maybe The wire that goes to the oil pan is a ground wire and needs to go to

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...