...engine. faceing the car it is between the radiator and the head. It is driven by a small belt. It is removed by removing a cover plate that has the radiator host and by pass hose connected to it. it ...
...remove all and it should come free, the motor is at the front of the tranny it is attached to the flywheel, disconnect battery first On older Cads with the Northstar engine the starter is in the ...
Center front of the engine, near the base of the engine oil dipstick tube. Access is from underneath the car. You will need to remove the plastic splash guard. The sensors are held in by one bolt each
how do you remove an oil pan on a 2002 deville? First the engine has to be removed from the car or at least jacked up at least 6 inches....then you simply unbolt it
...engine Hello, That belt drives the waterpump, if the belt came off then you have a problem. Either the pulley on the tensioner is locked up or the waterpump is locked up. It may have destroyed the ...
...engine coolant temp sensor is located just below the throttle body.Just remove the air cleaner tube and you should be able to see it.There will be a black and a yellow wire on the connector.Hope this ...
...engine light flashes at 20 mph, with car coasting and trans in nuetral light flashes till car gets down to 20 mph then it stays lite. Have replaced coil paks, plugs, and boots, remove battery cables ...
how to remove northstar engine 2002 caddilac deville not a clue yet!
Question about 2002 Deville
the front,and just not enough room to pull the rear valve cover out .any advice? To get at the back cover the engine needs to be rotated forward. To remove the front cover, you need to pull the pulley
...Remove the cap from the surge tank. Set the heater control temp to max (A/C in any mode EXCEPT max). Start the engine and idle until lower radiator to pump hose is hot. Allow the engine to cool to ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
