Questions & Answers for: remove engine 2000 mitsubishi galant

...engine. I have changed all the Cam shaft seals, balance shaft seal and the crank shaft pulley seal. I still have the same leak! Any ideas? it could also be the oil pan gasket, or the manifold gasket. ...

...remove the upper timing belt cover and do this quick inspection with someone that will tell you for sure. if it does look like it is spinning then by hand turn engine very slowly with plug coil wires ...

...2000 model with autobox hope you can help! Waterpump replacement requires removal and replacement of your timing belt. Because of this it is not your typical do it yourself repair. Engine timing is ...

Engine removal Can I remove the engine through the top or do I have to remove it from the bottom. you can do it from top,not that hard

...engine end of the radiator hose and pull the hose off the thermostat housing. 3. Step 3 Remove the two bolts on the thermostat housing cover and pull off the cover. Note the position of the old ...

...2000 mitsubishi GDI) someone removed them. is there a special way to set them up? idles too high and little throttle response. anything would help thanks Aaron. 3.0 V6 engine? Key on, engine off the ...

...2000 mitsubishi galant Your vehicle does not have a serviceable fuel filter. The 4 cylinder and 6 cylinder engines that are available in this vehicle have either a fuel pump module or a strainer,both ...

where is the thermostat located? drivers side of engine.remove air ducts to throttlebody and to air cleaner.then remove battrey and there youll have easy access.

...engine. ********* hose. Remove this hose from the engine side and this will be the throttle body/plate assembly. If it is black/oily inside, clean with carb spray and a toothbrush to remove any ...

...remove. 2.4L engine shown. Fig.2 - CKP reluctor removal Remove the sensor and slide the reluctor wheel off of the crankshaft-2.4L engine shown. 1. Disconnect the negative battery cable. 2. Remove the ...