Questions & Answers for: remove dash clean mouse nest

Question about 1990 Fleetwood

1 Answer

...system to clean out a mouse nest? The defroster wont blow when i turn it on and it smells like a mouse nest. U may be able to remove the blower motor and reach it, this is where they usually

Ad

Question about Motor 2004 Sonata

1 Answer

...Hundai Sonata, the fan for the A/C and heating systems stop working, I checked the fuses under the dash board and the fuses by the engine and they are ok. What can be de problem? good morning, common ...

Ad

...Hundai Sonata Automatic Door Lock Actuator? I have a new Actuator and need instructions to replace it? take all screws of ,,then take screws of actuator and cables then remove it ,,put in new one put ...

...to get a mouse nest out inside the dash where the heater fan is. The fan is making terrible noise. BLOWER MOTER IS UNDER FRT PASS FEET.. REMOVE BLOWER CLEAN OUT CAGE. SPRAY LYSOL TO KILL ANY

dash. It is hard to tell if I must remove the glove box, or if I can just take out the screws that hold the fan/motor assembly, drop them down, and get a small hose and shop-vac and clean out the duct

...blower motor housing, it will be full of leaves or a mouse has nested in there. The blower is under the dash on the passengers side, remove glove box and lower dash under panel to access the

Question about 1991 Pathfinder

1 Answer

...clean Mouse nest in heater Need to vacuum out heater. Can I do this without removing the dash? Hi Allen,it's simple to do,don't have to remove dash,here's a link to removing the blower motor and

2013 Hyndai Sonata red flashing light on BOTTOM, LOWER driver side dash I have typed this 5 times already just to do it again. Just bought 2013 Sonata GLS with preferred package, (alloys,fog lamps,eco

...remove the dash/windshield panel. the nest is right under the dash. I could not vacum it out. The air breather hose may come out but this does not look easy either) then I may be able to clean out ...

mouse nest in my engine. I removed all the nest and found the casing for the fuel injector wires had been chewed but the wires were still intact. I wrapped them with electrical tape. No other signs of

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...