Questions & Answers for: remove cross head tap

...Remove 2 cross-head screws holding the door - Door will come away from dryer. Remove 2 cross-head screws holding the white top and bottom blanking plates pull out the switch blanking plate Locate the ...

cross-threaded spark plug threads on 2007 stratoliner 1900. right , rear cylinder. What can be done without removing the head? You need to get hold of the correct "TAP", with a get deal of care re-tap

remove the headgear from my dripping hot tap in the bathroom which was fitted circa 1999 I have taken the plastic cap off and then faced with a screw head I do not recognise, it is neither a flat head

...remove the headgear from my dripping hot tap in the bathroom which was fitted circa 1999 I have taken the plastic cap off and then faced with a screw head I do not recognise it is neither a flat head ...

...cross between flat head and star. anyway once you remove cover you should see the bearing in the center. you need to use a bearing/gear puller to remove it. the magnetic ring lays just beneath the ...

...remove the collar and the base, handle will still not come off im not 100%sure on the particular set of taps you have ,but by looking at the picture on screen ill hazard a quess.by the way im a ...

...remove the cross head screws securing the spring cover, BE AWARE THERE IS A COMPRESSION SPRING UNDER HERE, eye protection should be worn, with the cover off, pry out the spring, remover the small pin ...

remove the tap cross head. I think it needs a key of some sort top pop it off. Please help!!!! It may just pull straight up... or , there could be a retaining screw ... turn the handle and inspect the

remove the plug. If it was cross threaded in, you will have to tap the threads and use a repair kit for spark plugs. It will come with neccessary parts to repair. If plug was just rusted in, chase the

...advice? the plug has been cross threaded in the hole remove it and try to get it in properly you may need a thread tap to reform the thread in the head or a thread insert if the thread is badly ...