Questions & Answers for: Suzuki Forenza remove cover

Question about 2004 Forenza

1 Answer

...remove plastic spark plug cover. Jack up engine about an inch remove engine mount. Now you can access sensor through a convenient cover that mounts around engine mount bracket extending from engine ...

Ad

suzuki forenza thermostat 2004, 56000m can i change this myself? how step by step? Heat is out and engine overheating...could it be anything else? yas you can, drain the cooling system,disconnect the ...

Ad

Question about 2007 Forenza Sedan

2 Answers

Remove the trim cover by removing the two bolts holding it down with a 5mm hex drive or allen wrench and gently lifting up. Underneath you will find the plugs. Remove the rubber boots without damaging

Question about 2006 Forenza

1 Answer

Headlight cover How do you take off the headlight cover to get to the bulb? the cover doesn t come off you have to remove the things behind the light like the battery and the caps screw off

Question about 2006 Forenza

1 Answer

cover. Remove the air cleaner housing bolts. Remove the air cleaner housing. Remove the right front wheel. Remove the right front wheel well splash shield. Remove the serpentine drive belt. Remove the

...cover. Remove the air intake tube. Disconnect the throttle cables by opening the throttle and moving the cable through the release slot. Disconnect the vacuum hoses from the throttle body. Disconnect ...

Question about 2004 Forenza

2 Answers

...cover) remove the valve cover using both hands, and equal pressure applied by each hand. Valve Cover Gasket - Replace Installing a valve cover gasket is typical of most installations of stamped steel ...

...remove them because the cover brakes easily. You have to bent the little metal tab that holds the seal in place and pry the seal out with a bent screw driver or a small pry bar or a seal remover that ...

Question about 2007 Forenza Wagon

1 Answer

How do I remove the rear wiper arm. The cover pops off. Remove the nut , wiggle it off and replace.

...Remove the heater core cover screws from the heater core housing. 9. Remove the heater core. Installation 1. Install the heater core into the case. 2. Install the screws on the heater core housing. ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...