Questions & Answers for: Chevrolet Monte Carlo remove cover

cover , remove the pinion shaft lock screw , and pinion shaft , push axel(s) inward and remove the C lock(s) ? at that point remove axel by sliding axel out . if thats a fix ya , please vote , thanks

Ad

Question about 1997 Monte Carlo

1 Answer

...cover on. Remove the cover, clean the area up, making sure it's dry. Lift the thermostat out, and put the new one on exactly as the old one was. It is possible to put it on backwards, and that will ...

Ad

Question about 2004 Monte Carlo

1 Answer

...cover. 10. Remove the rear floor air outlet duct. 11. Remove the heater air outlet cover screws (2). 12. Remove the heater air outlet cover heat stakes (1) with a small chisel. 13. Remove the heater ...

remove the cover plate screws, then disconnect the switches and the cigar lighter (if equipped) from the electrical harness. 4. If equipped with an integral armrest, remove the screws inserted through

Question about 2002 Monte Carlo

1 Answer

...Remove the fuel injection appearance cover (if it has one) Drain cooling system Disconnect heater hoses Rmv. right/left instrument panel closeouts Rmv. the carpet Rmv. rear floor air outlet duct from ...

cover. Remove oil pan retaining nuts and bolts. Remove lower frame and powertrain onto transmission table. Remove the front cover, as outlined earlier this section. Matchmark the intermediate sprocket

Question about 2004 Monte Carlo

2 Answers

...cover and remove it from the hose. Shake it to see if the valve moves back and forth. If not, replace. Actually, it is located on passenger side of the intake-manifold, within the assembly which ...

Question about 2004 Monte Carlo

1 Answer

...remove the valve cover to my 3.4 litre 2001 chevy monte carlo. how do i remove the valve cover on the firewall side? and also where are all the bolts located. possibly a diagram would be greatly ...

Question about 1999 Monte Carlo

1 Answer

...a engine light support engine you have to remove oil pan so bottom part timing cover will seal correctly if you dont remove oil pan bottom timing cover seal will be in a bind you will have oil

Question about 1998 Monte Carlo

1 Answer

...remove an access cover plate, or more likely, the transmission's bottom cover to access the filter. If no drain plug, oil will "self-remove" when you loosen the cover - be sure you have a large drip ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...