Questions & Answers for: Jeep remove cover

Question about 2007 Commander Rocky Mountain

1 Answer

...(5) from housing cover (spring clips retain cover to housing). 3. Release housing cover (3) from locating tabs on housing and remove cover (3). 4. Remove air cleaner element (filter) from

Ad

Question about 1994 Grand Cherokee

2 Answers

...cover. Remove the pins. Now for the final step, you will have to remove the 2 mud guards screws in each rear wheel well. Ths requires a good philips head screwdriver. You can pull the fender towards ...

Ad

...cover. remove the cover and clean all the gasket off the engine and the cover. use a razor blade, and make sure there in no oil or grease on the parts where the gasket lies. Put your gasket on, bolt ...

Question about 2001 Grand Cherokee

1 Answer

...Remove thermostat housing mounting bolts, thermostat housing and thermostat. To install: Clean mating areas of timing chain cover and thermostat housing. Install thermostat (spring side down) into ...

Question about 2001 Grand Cherokee

1 Answer

...remove the valve cover, I don't believe there exists such a diagram. Typically, valve covers are only one or two parts at most. You simply remove the attaching bolts and work it through the hoses and ...

Question about 2001 Grand Cherokee

1 Answer

...remove the cover to change the air filter on my 05 grand jeep cherokee Remove the duct that goes to the throttle body (engine or filter box end does not matter) Around the perimeter of the top of the ...

...cover. Remove the A/C compressor, if equipped, and alternator bracket from the cylinder head and move to one side. Remove the oil pan-to-timing case cover bolts and the cover-to-cylinder block bolts. ...

Question about 1996 Grand Cherokee

1 Answer

...cover, Remove wire loom clips, note the locations of the studs. Remove accelerator cable, kick-down cable and cruise-control cable from the snap in clips on top of valve cover, disconnect them at the ...

Question about 2005 Wrangler

1 Answer

Hold the camshaft sprocket with Special Tool 6847, or equivalent, while removing the center bolt. Remove the timing belt idler pulley. Remove the rear cover fasteners and remove the cover from engine

...REMOVE HEADREST TO PUT ON SEAT COVERS XK Commander. i have no XK books, sorry. but.. opr guide? RTM it's free a jeep, down load it and read? it does not cover removal only up and down. front row or ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...