Galant Special Edition 1994 Motor does not start Engine was running normally. Then lost power but was running OK but weas hard to accelerate Stoped on next traffic light but engine cut off but ...
coil pack setup, you need to remove the coils from the top of the plugs, and just replace the plugs then using a sparkplug socket, and replace the coil pack after so you can fire the engine, only do 1
...remove. You need to disconnect the wire on the starter coil (the coil is located on top of the starter itself). Now the fun part: removing the the starter itself. The way I did it is by wriggling it ...
...coil,remove the coil HT lead that runs to the cap from the cap,place near an area that is earthed and crank engine,should see a spark jump to the metal object. Both early and later models run modules ...
...cover, This type ignition system is referred to as a "Direct Fire" igntion system for obvious reasons. Remove the coils (one for each engine cylinder to access the plugs. See picture of coil
...REMOVE THE COIL SCREW THEN UNPLUG THE COIL ELECTRICAL CONNECTOR.REMOVE COIL, THEN YOU CAN REMOVE SPARK PLUG.YOU WILL NEED A LONG EXTENSION AND A LONG SPARK PLUG SOCKET TO REMOVE SPARK PLUG. Find the ...
no spark to plugs COIL NOT SUPPLING POWER TO SPARK PLUGS REMOVE COIL REPLACE
...coil wires and spark plug wires. Remove the spark plug wires, valve cover bolts and the valve cover. Unplug the electrical connections from the intake manifold runner control actuator. Unfasten the ...
remove the bolt on the coil and pull it up and out. The plugs will be seen strait down in the valve cover from there and remove the same as any plug will. I really recommend using a high quality plug.
coil.3 If your DVOM shows that voltage is present at both locations, remove the DVOM leads and set the meter aside. Connect the ground lead from the 12-volt test light to the negative terminal on
Usually answered in minutes!
851 Questions
799 Questions
747 Questions
704 Questions
325 Questions