Cylinder 1 and 4 misfire on my 1997 Ford Explorer My Ford Explorer is running rough, stalls when at low speeds/sitting idle. I am getting two codes ......Cylinder 1 and 4 misfire detected. I have put ...
remove it from the coil.) ------------------------However, I suspect that you will have the coil energized and that the engine will turn over....since the key is not in the ON position, the motor will
...remove the coil pack let me know, to test put on ohms should not have more than 2 1/2 ohms restance betweent coil lead to coil connector. If you test the coil pack on both sides of the pack and get a ...
...coil and remove the coil and boot. Use compressed air to blow all of the dust/dirt out from the plug area. Removing the dirt is extreemly important. Remove th plugs and replace with a high quality ...
Remove the coil and there is a boot that looks like a spark plug wire end. You can buy those from auto parts store, I would replace those along with plugs.You can remove the plugs with plug socket and
...remove the coil, once you remove the coil take a spark plug socket and extension to remove the plug.On the end of each coil is a boot that looks like the end of a spark plug wire . You can buy a set ...
...EACH INDIVIDUAL COIL.DISCONNECT COIL ELECTRICAL CONNECTOR.THEN REMOVE COIL RETAINING BOLT.THEN REMOVE OFF SPARK PLUG.THEN REPLACE SPARK PLUG.YOU HAVE 8 COILS TO REMOVE BEFORE REPLACING SPARK
...the codes and wait for the codes to return. If the code P030_ shows up, (P0302 if you swapped it with #2, P0303 for #3, for example) Then remove that coil and get you
remove radiator from 1999 ford Explorer Can you get the radiator out without taking the condenser coil out? Condenser coil should unbolt from the radiator
How do you remove the radiator Can your remove the radiator without removing the condenser coil? Yes it is better to remove the radiator and keep the condenser in place it tack more time
Usually answered in minutes!
2,998 Questions
2,307 Questions
2,248 Questions
2,302 Questions
1,513 Questions