Questions & Answers for: Dodge Intrepid how to remove the coil

...negative terminal on battery,then disconnect wire connector at each coil pack and remove 2 screws that hold down coil pack, pull gently straight up and plug is right there below coil ...

Ad

...coil and Modules. NOW if you have Spark on All 6 Cylinders Check for fuel delivery, Do this at the shrader Valve on the fuel rail,(LOOKS LIKE AIR FILL VALVE ON WHEELS) Simply remove cap turn key on ...

Ad

remove the coil from inside the boot and slide the boot over the spark plug and start to thread the plug back in. Using this method allows to you feel if you are threading the plug in right. Then with

remove the coil from inside the boot and slide the boot over the spark plug and start to thread the plug back in. Using this method allows to you feel if you are threading the plug in right. Then with

...and runs again and stops take a inline spark tester and connect between the coil and the spark plug wire to check for fire. If no fire then remove the coil and replace it. hope this will help

...Vehicle purchased from an Auction and would not start. The vehicle would only backfire. When I removed the valve covers I found that one of the rocker arms had popped out. I replace the heads ...

...coil pack itself is at fault, but be aware that parts stores don't accept returns for electrical components if replacing something doesn't fix your problem. I'm not aware of airbag problems affecting ...

Question about 2000 Intrepid

1 Answer

...Coil-On-PlugRemoval & InstallationTo Remove: Before servicing the vehicle, refer to the precautions in the beginning of this section. Remove or disconnect the following: Electrical connector from ...

Question about 1996 Intrepid

2 Answers

...coil. Remove ignition coil assembly. Remove the spark plug using a quality socket with a rubber or foam insert. Inspect the spark plug condition. INSTALLATION Always remove the ignition coil assembly ...

Question about 1996 Intrepid

1 Answer

...remove the high voltage coil wire. ( That's the wire in the center of the distributor cap.) Using a good pair of insulated pliers. I want you to hold it about 1/4 inch from a good engine ground. Now ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...